P6200069 Medium Resolution
Low
|
High
Resolution
1) Lube the rubber sleeve in the AEM package 2) Slide two clamps onto the rubber sleeve 3) Slide the rubber sleeve onto the top of the tube near the engine. 4) Note: the end of the tube should go in as far as possible! If there is any 'loose' space, push the sleeve further up onto the intake tube (easiest if you push down on the sleeve so it slides down over the intake tube. If you have slack space, you may have problems getting everything to fit! Tighten the clamps slightly, but not a lot! There is much adjusting to do! You can try to get the pipe ends into the Bypass valve, but odds are.... |
Previous
---
Index
---
Next
Previous
---
Index
---
Next
Picture info:
Date: 2001-06-20 20:03:51
Camera: OLYMPUS OPTICAL CO.,LTD C2020Z
Focal Length: 35mm
Shutter: 1/30s
F/2
ISO: 100
Flash used